Product Information


Advantage Microcontrollers™

Q1. What is the maximum operating frequency of Oki's Advantage Microcontrollers™?
...more
Q2. Can I run Windows CE or Linux on Oki's ARM7 MCUs?
...more
Q3. What is the benefit of having the Mode[0:2] pins on the ML674000 as opposed to handling these tasks through software?
...more
Q4. When using the ML674000 CPU board in Normal Mode, I cannot seem to access the Flash memory part 0xc820_0000. The memory that I see at that address seems to be a mirror of the SRAM memory.
...more
Q5. Given that the address pins XA[19:23] of the ML674000 MCU are the secondary function of PIOA pins, how can I boot from a memory that needs to use these address pins?
...more
Q6. How many hardware breakpoints do ML67K MCUs support?
...more
Q7. How do I configure the Port B GPIO pins of the ML674000 to their primary function as GPIO pins?
...more
Q8. What are the maximum data transmission rates for the UARTs on Oki's Advantage Microcontrollers?
...more
Q9. Can I use the SSIO peripheral of advantage MCUs for SPI communication?
...more
Q10. What is the maximum speed of the SSIO port of advantage MCUs?
...more
Q11. How are the chip select addressing on the I/O banks of ML674K MCUs divided?
...more
Q12. How can I program the flash of Oki Advantage Microcontrollers during software development?
...more
Q13. Can I over-write the program in the boot ROM of ML674K/ML675K MCUs?
...more
Q14. Is the firmware source code in the boot-ROM of ML674K/ML675K MCUs available as reference?
...more
Q15. Will the boot-ROM of ML674K and ML675K MCUs, function at various MCU clock frequencies and various UART baud-rates?
...more
Q16. What are the different memory types supported by ML674000?
...more
Q17. Can I debug my code out of internal/external ROM?
...more
Q18. Can I remap external memory banks of Oki's Advantage Microcontrollers to bank 0 during debugging?
...more
Q19. What are the different memory types supported by Oki's ML674000, ML674001 and ML675001 series MCUs?
...more
Q20. Why does Oki's ARM-based MCUs have a separate pin for resetting the system and the JTAG interface?
...more
Q21. Does Oki's ARM-based MCUs support Boundary Scan over the JTAG interface?
...more
Q22. How should the JTAG reset (nTRST) pin be treated on Oki ARM MCUs?
...more
Q23. What is the SIO port of Oki’s Advantage Microcontrollers?
...more
Q24. Why is it that when writing to certain R/W registers of Oki’s Advantage Microcontrollers, the write does not take effect?
...more