Advantage Microcontrollers™

What is the maximum operating frequency of Oki's Advantage Microcontrollers™?

 

Can I run Windows CE or Linux on Oki's ARM7 MCUs?

 

What is the benefit of having the Mode[0:2] pins on the ML674000 as opposed to handling these tasks through software?

 

When using the ML674000 CPU board in Normal Mode, I cannot seem to access the Flash memory part 0xc820_0000. The memory that I see at that address seems to be a mirror of the SRAM memory.

 

Given that the address pins XA[19:23] of the ML674000 MCU are the secondary function of PIOA pins, how can I boot from a memory that needs to use these address pins?

 

How many hardware breakpoints do ML67K MCUs support?

 

How do I configure the Port B GPIO pins of the ML674000 to their primary function as GPIO pins?

 

What are the maximum data transmission rates for the UARTs on Oki's Advantage Microcontrollers?

 

Can I use the SSIO peripheral of advantage MCUs for SPI communication?

 

What is the maximum speed of the SSIO port of advantage MCUs?

 

How are the chip select addressing on the I/O banks of ML674K MCUs divided?

 

How can I program the flash of Oki Advantage Microcontrollers during software development?

 

Can I over-write the program in the boot ROM of ML674K/ML675K MCUs?

 

Is the firmware source code in the boot-ROM of ML674K/ML675K MCUs available as reference?

 

Will the boot-ROM of ML674K and ML675K MCUs, function at various MCU clock frequencies and various UART baud-rates?

 

What are the different memory types supported by ML674000?

 

Can I debug my code out of internal/external ROM?

 

Can I remap external memory banks of Oki's Advantage Microcontrollers to bank 0 during debugging?

 

What are the different memory types supported by Oki's ML674000, ML674001 and ML675001 series MCUs?

 

Why does Oki's ARM-based MCUs have a separate pin for resetting the system and the JTAG interface?

 

Does Oki's ARM-based MCUs support Boundary Scan over the JTAG interface?

 

How should the JTAG reset (nTRST) pin be treated on Oki ARM MCUs?

 

What is the SIO port of Oki’s Advantage Microcontrollers?

 

Why is it that when writing to certain R/W registers of Oki’s Advantage Microcontrollers, the write does not take effect?